| Parte No | Fabricante | Aplicación |
|---|
| MAX483ECSA | MaximIC | +-15kV ESD-protected, low-power, RS-485/RS-422 transceiver. Half-duplex. Data rate 0.25Mbps. Slew-rate limited - yes. Low-power shutdown - yes. Receiver/driver enable - yes. Quiescent current - 120 microA. Number of transmitter on bus - 32. |
| MAX6313UK37D3-T | MaximIC | Multiple-input, programmable reset IC (push/pull reset output,factory-set reset threshold on Vcc, 1 additional undervoltage reset input,negative/overvoltage reset input).Factory-trimmed reset thresholds 3.608(min) 3.793(max).Nominal timeout period 140ms. |
| ICL7109CQH | MaximIC | 12 bit A/D converter with 3-state binary outputs |
| MAX6306UK27D4-T | MaximIC | Multiple-input, programmable reset IC (open-drain reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual reset input). Factory-trimmed reset thresholds 2.633(min),2.768(max) Nominal timeout period 1120ms. |
| MX636JN | MaximIC | 100mV. Auxiliary dB output 50dB range. Low power 0.8mA(typ). |
| MAX6321HPUK30AX-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.000V, reset timeout(min) 1ms, watchdog timeout(typ) 102ms |
| MAX110BCWE | MaximIC | Low-cost, 2-channel, 14-bit serial ADC. |
| MAX1248BCEE | MaximIC | +2.7V to 5.25V, low-power, 4-channel, serial 10-bit ADC. INL (LSB) +1,-1 |
| MAX397CQI | MaximIC | Precision, dual 8-channel, low-voltage, CMOS analo0g multiplexer. |
| MAX695EJE | MaximIC | Microprocessor supervisory circuit. |
| MAX1245BCAP | MaximIC | +2.375V, low-power, 8-channel, serial 12-bit ADC . |
| MAX516AENG | MaximIC | Quad comparator with programmable threshold. Error (LSB) +-1 |
| MAX746ESE | MaximIC | High-efficiency, PWM, step-down, N-channel DC-DC controller |
| MAX6321HPUK28CY-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 2.800V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| SI7661CSA | MaximIC | CMOS voltage converter |
| MAX189BMJA | MaximIC | +5V, low-power, 12-bit serial ADC. Error(LSB) +-1. |
| MAX6321HPUK45AZ-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.500V, reset timeout(min) 1ms, watchdog timeout(typ) 25.6sec |
| DG387CWE | MaximIC | General purpose CMOS dual analog switch. |
| MAX533BC/D | MaximIC | 2.7V, low-power, 8-bit quad DAC with Rail-to-Rail output buffer. INL (LSB) +-2 |
| MAX368MJN | MaximIC | Fault-protected analog multiplexer with latch. 8 channel single-ended (1 of 8). |
| MAX4513C/D | MaximIC | Quad, Rail-to-Rail, fault-protected, SPST analog switch. |
| MAX223C/D | MaximIC | +5V-powered, multichannel RS-232 driver-receiver. |
| MX7533AQ | MaximIC | CMOS low-cost 10 bit multiplying D/A converter. Error 0.2% |
| MAX9686MTV | MaximIC | Single very fast TTL output comparator |
| MAX6354LTUT-T | MaximIC | Dual-voltage microprocessor supervisory circuit with manual reset. Reset threshold 4.63V (Vcc5) and 3.08V (Vcc3). Active-low push-pull reset 3V. |
| MAX6711SEXS-T | MaximIC | Microprocessor reset circuit with manual reset input. Reset threshold 2.93V. Output type active-low push-pull reset. |
| MAX6321HPUK35AZ-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.500V, reset timeout(min) 1ms, watchdog timeout(typ) 25.6sec |
| MAX6310UK36D2-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 3.510(min),3.690(max). Nominal timeout period 20ms. |
| MAX4074ABEUK-T | MaximIC | Micropower, Rail-to-Rail, fixed-gain, single, GainAmp op amp. Inverting gain 0.25V/V, noninverting gain 1.25V/V, -3dB BW 200kHZ. |
| MAX329CWE | MaximIC | Ultra-low lealage monolithic CMOS analog multiplexer. |
