| Parte No | Fabricante | Aplicación |
|---|
| MAX3100CPD | MAXIMIC | SPI/Microwire-compatible UART in QSOP-16. |
| MAX6320PUK44BZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.390V, reset timeout(min) 20ms, watchdog timeout(typ) 25.6sec |
| MAX712CSE | MAXIMIC | NiCd/NiMH battery fast-charge controller (by detecting zero voltage slope). |
| MAX4521EPE | MAXIMIC | Quad, low-voltage, SPST analog switch. |
| MAX967EUA | MAXIMIC | Dual, micropower, ultra-low-voltage, Rail-to-Rail I/O comparator. Internal reference. Programmable hysteresis. |
| MAX4602EWE | MAXIMIC | Low on-resistance (2.5om max), quad, SPST, CMOS analog switches (four NO switches). |
| DG421DK | MAXIMIC | Improved low-pover, CMOS analog switches with latches |
| MAX1457C/D | MAXIMIC | 0.1%-accurate signal conditioner for piezoresistive sensor compensation. |
| MAX6317HUK30AX-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.000V, min reset timeout 1ms, typ watchdog timeout 102ms |
| MAX6321HPUK46CY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.630V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX1246ACPE | MAXIMIC | +2.7V, low-power, 4-channel, serial 12-bit ADC. INL (LSB) +1/2,-1/2 |
| MAX747CPD | MAXIMIC | High-efficiency, PWM, step-down P-channel DC-DC controller |
| MAX178BMRG | MAXIMIC | Calibrated 12-bit ADC with T/H and reference. |
| MAX6316LUK37DY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 3.700V, min reset timeout 1.12sec, typ watchdog timeout 1.6sec |
| ICM7218DIQI | MAXIMIC | 8 digit LED display driver |
| MXD1013SA070 | MAXIMIC | 3-in-1 silicon delay line. Output delay 70ns. |
| MAX6316LUK37CY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 3.700V, min reset timeout 140ms, typ watchdog timeout 1.6sec |
| MAX6320PUK50DZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 5.000V, reset timeout(min) 1.12sec, watchdog timeout(typ) 25.6sec |
| MAX7231AFIPL | MAXIMIC | Triplexed LCD decoder/driver (8 digits/7 segments; parallel input format; 2 annunciators per digit) |
| MAX6318LHUK38CZ-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 3.800V min, reset timeout 140ms,typ watchdog timeout 25.6sec |
| MAX683EUA | MAXIMIC | 3.3V-input to regulated 5V-output charge pump |
| DG212CSE | MAXIMIC | Quad SPST CMOS analog switch. |
| MAX6351MRUT-T | MAXIMIC | Dual-voltage microprocessor supervisory circuit with manual reset. Reset threshold 4.38V (Vcc5) and 2.63V (Vcc3). Active-low push-pull reset output 5V and 3V. |
| MAX513CPD | MAXIMIC | Low-cost, triple, 8-bit voltage-output DAC with serial interface. |
| ICL7622DCPD | MAXIMIC | Dual operational amplifier, 15mV |
| MAX349EPN | MAXIMIC | Serially controlled, low-voltage, 8-channel multiplexer |
| MAX810TEXR-T10 | MAXIMIC | Microprocessor reset circuit. Reset threshold 3.08V. Push-pull active-high reset. 10k increments. |
| MAX464ENI | MAXIMIC | Two-channel, quad RGB switch and buffer. Voltage gain 1V/V. |
| MAX6320PUK41DY-T | MAXIMIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.100V, reset timeout(min) 1.12sec, watchdog timeout(typ) 1.6sec |
| MAX407ESA | MAXIMIC | 1.2microA max, dual, single-supply op amp. |
