| Parte No | Fabricante | Aplicación |
|---|
| MX7533BQ | MaximIC | CMOS low-cost 10 bit multiplying D/A converter. Error 0.1% |
| DG418C/D | MaximIC | Improved, SPST, NO analog switch |
| MAX457EJA | MaximIC | Dual CMOS video amplifier. |
| MX574AKEPI | MaximIC | Industry standard complete 12-bit A/D converter. 25 microsec. max conversion time. Linearity (LSBs) 1/2. TEMPCO(ppm/C) 38. |
| MX7535AD | MaximIC | Microprocessor-compatible, 14-bit DAC. INL +-2 LSB. |
| MAX389EWG | MaximIC | High-voltage, fault-protected analog multiplexer. 4-channel differential (2 of 8). |
| MAX6317HUK38BY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.800V, min reset timeout 20ms, typ watchdog timeout 1.6sec |
| MAX6321HPUK28BZ-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 2.800V, reset timeout(min) 20ms, watchdog timeout(typ) 25.6sec |
| MAX3089CPD | MaximIC | Fail-safe, high-speed (10Mbps), slew-rate-limited RS-485/RS-422 transceiver |
| MAX6333UR24D3-T | MaximIC | Ultra-low-voltage, low power microprocessor reset circuit. Reset threshold(typ) 2.4V, reset timeout(min) 100ms. |
| MAX6316MUK37AX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 3.700V, min reset timeout 1ms, typ watchdog timeout 102ms |
| MAX4175BCEUK-T | MaximIC | Single, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 15, 1+ (Rf/Dg) noninverting gain 16, -3dB BW 390kHz. |
| MAX4074AJESA | MaximIC | Micropower, Rail-to-Rail, fixed-gain, single, GainAmp op amp. Inverting gain 3V/V, noniverting gain 4V/V, -3dB BW 90kHZ. |
| MX7524UQ | MaximIC | CMOS 8-bit buffered multiplying DAC. TTL/CMOS compatible at +5V. Error +-1/8 LSB |
| MAX6319MHUK27A-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 2.700V, reset timeout(min) 1ms |
| MAX6318MHUK49AX-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 1ms, watchdog timeout(typ) 102ms |
| MAX6313UK49D1-T | MaximIC | Multiple-input, programmable reset IC (push/pull reset output,factory-set reset threshold on Vcc, 1 additional undervoltage reset input,negative/overvoltage reset input).Factory-trimmed reset thresholds 4.778(min) 5.023(max).Nominal timeout period 1ms. |
| MAX453CPA | MaximIC | CMOS 50MHz video amplifier with an on-board multiplexer offering 2-channels |
| MAX4574CEI | MaximIC | Serially controlled, clickless audio/video switch. 3-wire, SPI/QSPI/MICROWIRE - compatible. |
| MAX1609EEE | MaximIC | Octal SMBus-to-parallel I/O expander |
| MAX6318MHUK49CW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 140ms, watchdog timeout(typ) 6.3ms |
| MAX703CSA | MaximIC | Low-cost microprocessor supervisory circuit with battery backup. Precison supply-voltage monitor 4.65V. |
| IH5048C/D | MaximIC | CMOS analog switch. |
| MAX3241EAI | MaximIC | 3.0V to 5.5V, low-power, up to 1Mbps, true RS-232 transceiver using four 0.1microF external capacitor. Low supply current 300microA. Guaranteed data rate 120kbps. |
| MAX4506MJA | MaximIC | Fault-protected, high-voltage, signal-line protector |
| MAX806TESA | MaximIC | 3.0V or 3.3V microprocessor supervisory circuit. Reset threshold 3.075V. Active-low reset. Manual reset input. Backup-battery switch. Power-fail threshold accuracy +-2%. Power-fail comparator. Reset window +-2% |
| MX7545CQ | MaximIC | CMOS 12-bit buffered multiplying DAC. Error +-1/2 LSB. |
| MAX6334UR20D2-T | MaximIC | Ultra-low-voltage, low power microprocessor reset circuit. Reset threshold(typ) 2.0V, reset timeout(min) 20ms. |
| MAX457CPA | MaximIC | Dual CMOS video amplifier. |
| MAX6316LUK48BX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 4.800V, min reset timeout 20ms, typ watchdog timeout 102ms |
