| Parte No | Fabricante | Aplicación |
|---|
| MAX6322HPUK42A-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.200V, reset timeout(min) 1ms |
| ICL7621ACSA | MaximIC | Dual operational amplifier, 2mV |
| DG202CSE | MaximIC | Quad SPST CMOS analog switch. |
| MAX792SEJE | MaximIC | Microprocessor and non-volatile metory supervisory circuit. Reset threshold 2.91V |
| MAX4508CAE | MaximIC | Fault-protected, high-voltage single 8-to-1 multiplexer. |
| MAX6504CMN025-T | MaximIC | Low-cost, +2.7V to +5.5V micropower temperature switch. Output stage push-pull. Standard temperature threshold(C) -25. |
| MAX985ESA | MaximIC | Single, low-power, Rail-to-Rail I/O comparator. Push/pull output stage sinks and sources. |
| MAX6317HUK26BX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 2.630V, min reset timeout 20ms, typ watchdog timeout 102ms |
| MAX3766E/D | MaximIC | 622Mbps LAN/WAN laser driver with automatic power control and safety shutdown. |
| MAX6333UR20D2-T | MaximIC | Ultra-low-voltage, low power microprocessor reset circuit. Reset threshold(typ) 2.0V, reset timeout(min) 20ms. |
| MAX4274CAEUA | MaximIC | Dual, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 100, 1+ (Rf/Dg) noninverting gain 101, -3dB BW 230kHz. |
| MX7520LD | MaximIC | CMOS 10 bit multiplying D/A converter. Error 0.05% |
| MAX6318LHUK34AY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 3.400V min, reset timeout 1ms, typ watchdog timeout 1.6sec |
| MAX704CSA | MaximIC | Low-cost microprocessor supervisory circuit with battery backup. Precison supply-voltage monitor 4.40V. |
| MAX6318MHUK39CY-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.900V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX726ECK | MaximIC | 2A step-down, PWM, switch-mode DC-DC regulator. |
| MAX4552CPE | MaximIC | +-15kV ESD-protected, quad, low-voltage, SPST analog switches (four NO switches). |
| MAX453MJA | MaximIC | CMOS 50MHz video amplifier with an on-board multiplexer offering 2-channels |
| MAX778LCSA | MaximIC | Low-voltage input, step-up DC-DC converter |
| MAX3387EEUG | MaximIC | 3.0V, +-15kV ESD-protected, autoshutdown plus RS-232 transceiver for PDAs and cell phohes. |
| MAX906ESE | MaximIC | Dual, high-speed, positive edge-triggered, ECL-compatioble voltage comparator. |
| MAX250MLD | MaximIC | +5V powered isolated RS-232 driver/receiver. |
| MAX6320PUK48DX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.800V, reset timeout(min) 1.12sec, watchdog timeout(typ) 102ms |
| MAX547ACQH | MaximIC | Octal, 13-bit voltage-output DAC with parallel interface. INL(LSBs) +-2. |
| MAX6808US46-T | MaximIC | Voltage detector. Reset output active-low, open-drain. Threshold reset 4.6V |
| MAX1246BEPE | MaximIC | +2.7V, low-power, 4-channel, serial 12-bit ADC. INL (LSB) +1,-1 |
| MAX6310UK30D2-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 2.925(min),3.075(max). Nominal timeout period 20ms. |
| MAX6316LUK42CW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 4.200V, min reset timeout 140ms, typ watchdog timeout 6.3ms |
| MAX333C/D | MaximIC | Quad SPDT CMOS analog switch. |
| MAX159BCPA | MaximIC | +2.7V, low-power, 2-channel, 108ksps, serial 10-bit ADC in 8-pin microMAX. INL (LSB) +,- 1 |
