| Parte No | Fabricante | Aplicación |
|---|
| MAX3209EEUU | MaximIC | +-15kV ESD-protected, 12V, dual RS2342 serial port with low-power standby for motherboards/desktops. |
| MXL1014DS | MaximIC | Quad precision op amp. |
| DG200ACA | MaximIC | Dual monolithic SPST CMOS analog swith |
| MAX6317HUK34CZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.400V, min reset timeout 140ms, typ watchdog timeout 25.6sec |
| IH5140CPE | MaximIC | Low power fast CMOS analog switch. Single pole, single throw (SPST). |
| MAX492CPA | MaximIC | Dual, micropower, single-supply operation (+2.7V to +6V), Rail-to-Rail op amp. |
| MAX743MJE | MaximIC | Dual-output, switch-mode regulator (+5V to +/-15V or +/-12V) |
| MAX155BEPI | MaximIC | 8-channel ADC with simultaneous T/Hs and reference. Error +-1 LSB. |
| MAX6316MUK35CY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 3.500V, min reset timeout 140ms, typ watchdog timeout 1.6sec |
| MAX535BCUA | MaximIC | Low-power, 13-bit voltage-output DAC with serial interface. INL (LSB) +-1. +5V single-supply operation. |
| MAX487ECPA | MaximIC | +-15kV ESD-protected, low-power, RS-485/RS-422 transceiver. Half-duplex. Data rate 0.25Mbps. Slew-rate limited - yes. Low-power shutdown - yes. Receiver/driver enable - yes. Quiescent current - 120 microA. Number of transmitter on bus - 128. |
| MAX6306UK50D4-T | MaximIC | Multiple-input, programmable reset IC (open-drain reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual reset input). Factory-trimmed reset thresholds 4.875(min),5.125(max) Nominal timeout period 1120ms. |
| MAX4633MJE | MaximIC | Fault-protected, high-voltage, dual analog switch (two NO DPST switches). Fault protection +-40V with power off, +-36V with +-15V supplies. |
| MAX643BMJA | MaximIC | +15V fixed output, 10W CMOS step-up switching regulator. 10% output accuracy |
| MAX6321HPUK49BZ-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 20ms, watchdog timeout(typ) 25.6sec |
| MAX4538CEE | MaximIC | Quad, low-voltage, SPST analog switches with enable. 2 NO and 2 NC. |
| MAX4456CPL | MaximIC | Low-cost 8x8 video crosspoint switch. 65MHz -3dB bandwidth. |
| MAX4174BLEUK-T | MaximIC | Single, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 60, 1+ (Rf/Dg) noninverting gain 61, -3dB BW 310kHz. |
| MX674ATD | MaximIC | Industry standard complete 12-bit A/D converter. 15 microsec. max conversion time. Linearity (LSBs) 3/4. TEMPCO(ppm/C) 25. |
| MAX6241AESA | MaximIC | Low-noise, precision, +4.096V output voltage reference. Max TEMPCO (ppm/C) 3.0. |
| MAX6316LUK44AY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 4.390V, min reset timeout 1ms, typ watchdog timeout 1.6sec |
| MAX1647EAP | MaximIC | Chemistry-independent battery charger |
| MAX520AC/D | MaximIC | Quad, 2-wire serial 8-bit DAC with Rail-to-Rail, unbuffered outputs. TUE(LSB) 1. |
| MAX942CPA | MaximIC | Dual, high-speed, low-power, 3V or 5V single-supply, Rail-to-Rail comparator |
| MAX4490AUK-T | MaximIC | Single, low-cost, high-slew-rate, Rail-to-Rail I/O op amp. |
| ICM7211IPL | MaximIC | Four digit display decoder/driver. LCD, output code - hexadecimal, input configuration - multiplexed 4-bit |
| MAX525ACPP | MaximIC | Low-power, quad, 12-bit, voltage-output DAC with serial interface. INL(LSB) +-1/2. |
| MAX165BCPN | MaximIC | CMOS microprocessor-compatible, 5 microsec, 8-bit ADC. Error +-1 LSB. Plug-in upgrade to the MX7575. |
| MAX6320PUK48DW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.800V, reset timeout(min) 1.12sec, watchdog timeout(typ) 6.3ms |
| MAX6316MUK50CZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 5.000V, min reset timeout 140ms, typ watchdog timeout 25.6sec |
