| Parte No | Fabricante | Aplicación |
|---|
| MAX6501CMP075-T | MaximIC | Low-cost, +2.7V to +5.5V micropower temperature switch. Output stage open-drain. Standard temperature threshold(C) +75. |
| MAX6321HPUK33CZ-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.300V, reset timeout(min) 140ms, watchdog timeout(typ) 25.6sec |
| MAX6341CSA | MaximIC | Low-noise, +4.096V voltage reference. Max tempco 1.0ppm/C |
| MAX6321HPUK49BX-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 20ms, watchdog timeout(typ) 102ms |
| MAX766C/D | MaximIC | -15V or adjustable output from -1V to -16V, high-efficiency, low IQ DC-DC inverter |
| MAX6321HPUK30CX-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.000V, reset timeout(min) 140ms, watchdog timeout(typ) 102ms |
| MAX6318LHUK32DW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 3.200V min, reset timeout 1.12sec, typ watchdog timeout 6.3ms |
| MAX312EPE | MaximIC | 10Om, quad, SPST, CMOS analog switch |
| MAX6318LHUK37AW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 3.700V min, reset timeout 1ms,typ watchdog timeout 6.3ms |
| MAX187BMJA | MaximIC | +5V, low-power, 12-bit serial ADC. Error(LSB) +-1. |
| MAX7409EPA | MaximIC | 5th-order, lowpass, switched-capacitor filter. Filter response bessel, operating voltage +5V |
| MAX5154BCEE | MaximIC | Low-power, dual, 12-bit voltage-output DAC with serial interface. +5V single-supply operation. INL(LSB) +-1. |
| MAX6316LUK32BX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 3.200V, min reset timeout 20ms, typ watchdog timeout 102ms |
| MAX708SCSA | MaximIC | Low-cost, microprocessor supervisory circuit. Precison supply-voltage monitor 2.93V. Active-low and active-high reset output signal. |
| MAX388C/D | MaximIC | High-voltage, fault-protected analog multiplexer. 8-channel single-ended. |
| MAX6317HUK43CW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 4.300V, min reset timeout 140ms, typ watchdog timeout 6.3ms |
| MAX4550EWI | MaximIC | Serrially controlled, dual 4x2, clickless audio/video crosspoint switches. |
| MAX4588CWI | MaximIC | Low-voltage, high-isolation, dual 4-channel RF and video multiplexer. |
| MAX114C/D | MaximIC | 5 V, 1Msps, 4-channel, 8-bit ADC |
| OP90GS | MaximIC | Precision low voltage micropower operational amplifier. |
| MAX473MJA | MaximIC | Single, 10MHz single-supply op amp. |
| MAX4075AGEUA | MaximIC | Micropower, Rail-to-Rail, fixed-gain, dual, GainAmp op amp. Inverting gain 2V/V, noninverting gain 3V/V, -3dB BW 135kHZ. |
| MAX170DMJA | MaximIC | Serial output 5.6 microsec 12-bit A/D converter. Error +-1 LSB. |
| MAX487MJA | MaximIC | Low-power, slew-rate-limited RS-485/RS-422 transceiver. Half-duplex. Data rate 0.25Mbps. Slew-rate limited - yes. Low-power shutdown - yes. Receiver/driver enable - yes. Quiescent current - 120 microA. Number of transmitter on bus - 128. |
| MAX6378XR44-T | MaximIC | Ultra-low-power voltage detector, 4.4V |
| MX752BD | MaximIC | CMOS 8-bit buffered multiplying DAC. TTL/CMOS compatible at +5V. Error +-1/4 LSB |
| MAX5174BEEE | MaximIC | Low-power, serial, 12-bit DAC with voltage output. Single-supply +5V operation. Full-scale output range +2.048V(Vref=+1.25V). INL(LSB) +-2. |
| MAX6321HPUK43CY-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.300V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX274AEWI | MaximIC | 8th-order continuous-time active filter |
| MAX6316MUK48AX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 4.800V, min reset timeout 1ms, typ watchdog timeout 102ms |
