| Parte No | Fabricante | Aplicación |
|---|
| MAX359EWE | MaximIC | Fault-protected analog 4 channel differential (2 of 8) multiplexer. |
| MAX4374HEUB | MaximIC | Low-cost, micropower, high-side current-sense amplifier + comparator + reference IC. Gain +100V/V. |
| MAX552BEUB | MaximIC | +3V, 12-bit, serial, multiplying DAC. Linearity(LSB) +-1. |
| MAX6321HPUK38DY-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.800V, reset timeout(min) 1.12sec, watchdog timeout(typ) 1.6sec |
| MAX4667CSE | MaximIC | 2.5om, quad, SPST, CMOS analog switch (two NC switches). |
| MAX874ESA | MaximIC | 10microA, low-dropout, precision voltage reference. Output voltage 4.096V +-0.2%. Wide operating voltage range 4.3V to 20V. Line regulation over temp. 75microV/V. Load regulation over temp. 1.0mV/mA max |
| MAX804TC/D | MaximIC | 3.0V or 3.3V microprocessor supervisory circuit. Reset threshold 3.075V. Active-high reset. Watchdog input. Backup-battery switch. Power-fail threshold accuracy +-2%. Power-fail comparator. Reset window +-2% |
| MAX6318MHUK32DZ-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.200V, reset timeout(min) 1.12sec, watchdog timeout(typ) 25.6sec |
| MAX6316LUK44CY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 4.390V, min reset timeout 140ms, typ watchdog timeout 1.6sec |
| MAX6225BMJA | MaximIC | Low-noise, precision, +2.5V output voltage reference. Max TEMPCO (ppm/C) 8.0. |
| MAX6316LUK31DW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 3.080V, min reset timeout 1.12sec, typ watchdog timeout 6.3ms |
| MAX6346XR43-T | MaximIC | Microprocessor supervisory circuit (reset output active-low, push-pull). Reset threshold (typ) 4.300V. Order increment 10k |
| MAX517BESA | MaximIC | 2-wire serial 8-bit single DAC with Rail-to-Rail outputs. TUE(LSB) 1.5. |
| MAX4598CAP | MaximIC | Low-voltage, CMOS analog IC, combination single-ended 8-to-1/differential 4-to-1 multiplexer. |
| MAX3245CAI | MaximIC | 1microA supply current, 1Mbps, 3.0V to 5.5V, RS-232 transceiver with autoshutdown plus |
| MAX6346UR37-T | MaximIC | Microprocessor supervisory circuit (reset output active-low, push-pull). Reset threshold (typ) 3.700V. Order increment 10k |
| DG301AC/D | MaximIC | Quad, TTL compatible CMOS analog switche |
| MAX974EPE | MaximIC | Ultra-low-power, open-drain, quad comparator. Internal precision reference 1%. Internal hysteresis no. |
| MAX755EPA | MaximIC | Negative output, inverting, current-mode PWM regulator. Converts +2.7V to +9V input to adjustable negative output. |
| IH5045C/D | MaximIC | General-purpose CMOS analog switch. Dual, double pole, single throw (Dual DPST) |
| MXD1013C/D100 | MaximIC | 3-in-1 silicon delay line. Output delay 100ns. |
| MAX823SEUK | MaximIC | Microprocessor supervisory circuit. Reset threshold 2.93V. Active-low reset. Watchdog input. Manual reset input. |
| MAX6309UK37D3-T | MaximIC | Multiple-input, programmable reset IC (push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,manual-reset input).Factory-trimmed reset thresholds 3.608(min),3.793(max) Nominal timeout period 140ms. |
| MAX6316LUK30DX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 3.000V, min reset timeout 1.12sec, typ watchdog timeout 102ms |
| MX7828CQ | MaximIC | CMOS, high-speed, 8-bit ADC with multiplex. Error (LSB) +-1/2 |
| MAX6318MHUK38AX-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.800V, reset timeout(min) 1ms, watchdog timeout(typ) 102ms |
| MAX6319LHUK28B-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-low,push/pull and active-high, push/pull).Factory-trimmed reset threshold(typ) 2.800V, reset timeout(min) 20ms |
| MAX757ESA | MaximIC | 3.3V to 5V adjustable-output, step-up DC-DC converter. |
| MX7534BQ | MaximIC | Microprocessor-compatible, 14-bit DAC. INL +-1 LSB. |
| MAX6317HUK41CW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 4.100V, min reset timeout 140ms, typ watchdog timeout 6.3ms |
