| Parte No | Fabricante | Aplicación |
|---|
| MAX6312UK44D4-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual-reset input). Factory-trimmed reset thresholds 4.270(min) 4.490(max). Nominal timeout period 1120ms. |
| MAX537BMDE | MaximIC | Calibrated, quad, 12-bit voltage-output DAC with serial interface. +-5V supply operation. INL (LSB) +-1 |
| MAX861IUA | MaximIC | 50mA, Frequency-selectable, switched-capacitor voltage coverter. Input voltage +2.5V to 5.5V |
| ICL7653BCSA | MaximIC | Chopper-stabilized amplifier |
| MAX3100EPD | MaximIC | SPI/Microwire-compatible UART in QSOP-16. |
| MAX6318MHUK48CY-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.800V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX4074BHESA | MaximIC | Micropower, Rail-to-Rail, fixed-gain, single, GainAmp op amp. Inverting gain 40V/V, noninverting gain 41V/V, -3dB BW 67kHZ. |
| MAX1241CMJA | MaximIC | +2.7V, low-power, 12-bit serial ADCs in 8-pin SO. INL (LSB) +1 |
| MAX4553EPE | MaximIC | +-15kV ESD-protected, quad, low-voltage, SPST analog switches (two NO and two NC switches). |
| MAX6316LUK27AZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 2.700V, min reset timeout 1ms, typ watchdog timeout 25.6sec |
| MAX395MRG | MaximIC | Serially controlled, low-voltage, 8-channel SPST switch |
| MAX6318LHUK48BW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input, reset output active-low, push/pull; active-high,push/pull).Factory-trimmed reset threshold (typ) 4.800V, min reset timeout 20ms, typ watchdog timeout 6.3ms |
| MAX237CNG | MaximIC | +5V-powered, multichannel RS-232 driver-receiver. |
| MAX6316MUK50CY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 5.000V, min reset timeout 140ms, typ watchdog timeout 1.6sec |
| MAX1240BC/D | MaximIC | +2.7V, low-power, 12-bit serial ADCs in 8-pin SO. INL (LSB) +1 |
| MAX166CCPP | MaximIC | CMOS microprocessor-compatible, 5 microsec, 8-bit ADC. Error +-1/2 LSB. |
| MAX6319MHUK47A-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.700V, reset timeout(min) 1ms |
| MAX4146ESD | MaximIC | High-speed, low-distortion, differential line receiver. External gain selection +10V/V to 100V/V, 70MHz bahdwidth. |
| MAX6318MHUK50BX-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 5.000V, reset timeout(min) 20ms, watchdog timeout(typ) 102ms |
| MAX836EUS-T | MaximIC | Micropower voltage monitor. Open-drain output. |
| MAX6576ZUT | MaximIC | Temperature sensor with period output |
| MAX6318MHUK33AW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.300V, reset timeout(min) 1ms, watchdog timeout(typ) 6.3ms |
| MXD1013SE040 | MaximIC | 3-in-1 silicon delay line. Output delay 40ns. |
| MAX793SCSE | MaximIC | Microprocessor supervisory circuit. Reset threshold 2.85V to 3.00V. Active-low reset.Active-high reset.Low-line early warning output.Backup-battery switchover.External switch driver.Power-fail comparator.Battery OK output.Watchdog input.Manual reset inp. |
| MAX3232EWE | MaximIC | 3.0V to 5.5V, low-power, up to 1Mbps, true RS-232 transceiver using four 0.1microF external capacitor. Low supply current 300microA. Guaranteed data rate 120kbps. |
| MAX6320PUK48DZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.800V, reset timeout(min) 1.12sec, watchdog timeout(typ) 25.6sec |
| MAX6317HUK40BZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 4.000V, min reset timeout 20ms, typ watchdog timeout 25.6sec |
| MAX4614EUD | MaximIC | Low-woltage, high-speed, quad, SPST, CMOS analog switch has four NO switches. |
| MAX6325EPA | MaximIC | Low-noise, +2.5V voltage reference. Max tempco 1.5ppm/C |
| ICL7662EBD | MaximIC | CMOS voltage converter |
