| Parte No | Fabricante | Aplicación |
|---|
| MAX6310UK41D2-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 3.998(min),4.203(max). Nominal timeout period 20ms. |
| MAX6310UK47D3-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 4.583(min),4.818(max). Nominal timeout period 140ms. |
| MAX931CUA | MaximIC | Single low-power, low-cost comparator with intarnal 1.182V+-2% bandgap reference and internal programmable hysteresis.. |
| MAX180CCPL | MaximIC | Complete, 8-channele, 12-bit data-acquisition system. Error(LSB) +-1. |
| MAX6318MHUK29AW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 2.930V, reset timeout(min) 1ms, watchdog timeout(typ) 6.3ms |
| MAX2364ECM | MaximIC | Complete dual-band quadrature transmitter |
| MX7541AAD | MaximIC | CMOS 12 bit multiplying D/A converter. Error 1 LSB. |
| MAX6321HPUK47CZ-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.700V, reset timeout(min) 140ms, watchdog timeout(typ) 25.6sec |
| MAX232CSE | MaximIC | +5V-powered, multichannel RS-232 driver-receiver. |
| MAX6310UK29D1-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 2.857(min),3.000(max). Nominal timeout period 1ms. |
| MAX4174BKEUK-T | MaximIC | Single, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 50, 1+ (Rf/Dg) noninverting gain 51, -3dB BW 330kHz. |
| MAX992ESA | MaximIC | Dual, micropower, low-voltage, Rail-to-Rail I/O comparator. Open-drain output voltage extends beyond Vcc. |
| MAX483MJA | MaximIC | Low-power, slew-rate-limited RS-485/RS-422 transceiver. Half-duplex. Data rate 0.25Mbps. Slew-rate limited - yes. Low-power shutdown - yes. Receiver/driver enable - yes. Quiescent current - 120 microA. Number of transmitter on bus - 32. |
| MAX3486C/D | MaximIC | 3.3V-powered, 10Mbps and slew-rate-limited true RS-485/RS-422 transceiver. Guaranteed data rate 2.5Mbps. Supply voltage 3.0V to 3.6V |
| MAX642AEPA | MaximIC | +12V fixed output, 10W CMOS step-up switching regulator. 5% output accuracy |
| MAX4511C/D | MaximIC | Quad, Rail-to-Rail, fault-protected, SPST analog switch. |
| MAX6347UR33-T | MaximIC | Microprocessor supervisory circuit (reset output active-high, push-pull). Reset threshold (typ) 3.300V. Order increment 10k |
| MAX398MJE | MaximIC | Precision, 8-channel, low-voltage, CMOS analo0g multiplexer. |
| MAX731MJA | MaximIC | 5V step-up current-mode DC-DC converter |
| MAX6806US46-T | MaximIC | Voltage detector. Reset output active-low, push-pull. Threshold reset 4.6V |
| MAX712ESE | MaximIC | NiCd/NiMH battery fast-charge controller (by detecting zero voltage slope). |
| MAX6312UK47D4-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual-reset input). Factory-trimmed reset thresholds 4.583(min) 4.818(max). Nominal timeout period 1120ms. |
| MAX514AENG | MaximIC | CMOS quad, 12-bit, serial-input multiplying DAC. DNL(LSBs) +-1/2. |
| IH5041MJE | MaximIC | General-purpose CMOS analog switch. Dual, single pole, single throw (Dual SPST) |
| MX7542JN | MaximIC | CMOS microprocessor-compatible 12 bit DAC. Error +1 LSB. |
| MX7528LEWP | MaximIC | CMOS dual 8 bit buffered multiplying DAC. +5V to 15V single supply operation. Error +-1/2 LSB. |
| MAX4541EPA | MaximIC | Low-voltage, single-supply dual SPST analog switch. |
| MAX3287CUE | MaximIC | 3.0V to 5.5V, 1.25Gbps LAN laser driver. |
| DG405DJ | MaximIC | Improved, dual, DPST, NO, high-speed analog switch. |
| MAX122BCNG | MaximIC | 500ksps, 12-bit ADCs with track/hold and reference, INL (LSBs) +1 |
