| Parte No | Fabricante | Aplicación |
|---|
| MAX423C/D | MaximIC | +-15V chopper stabilized operational amplifier. |
| MAX4665CSE | MaximIC | 5om, quad, SPST, CMOS analog switch (four NO switches). |
| MAX190AEWG | MaximIC | Low-power, 12-bit sampling ADC with internal reference and power-down. Error(LSB) +-1/2. |
| ICL7631CMJE | MaximIC | Triple operational amplifier, 10mV |
| MAX662AEPA | MaximIC | +12V, 30mA flash memory programming supply |
| MAX821UUS-T | MaximIC | Microprocessor voltage monitor with pin-selectable power-on reset timeout delay (1ms,max, 20ms,min or 100ms,min). Reset threshold(nom) 2.78V. Active-low reset output. |
| MAX6318LHUK25BX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 2.500V min, reset timeout 20ms, typ watchdog timeout 102ms |
| MAX510AMJE | MaximIC | Quad, serial 8-bit DAC with Rail-to-Rail output. TUE (LSB) +-1 |
| MAX1659C/D | MaximIC | 350mA, 16.5V input, low-dropout linear regulator |
| MAX6316MUK31DZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 3.080V, min reset timeout 1.12sec, typ watchdog timeout 25.6sec |
| MAX7219CWG | MaximIC | Serially interfaced, 8-digit LED display driver. |
| MAX6317HUK42DY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 4.200V, min reset timeout 1.12sec, typ watchdog timeout 1.6sec |
| MAX535ACPA | MaximIC | Low-power, 13-bit voltage-output DAC with serial interface. INL (LSB) +-1/2. +5V single-supply operation. |
| MX565ATQ | MaximIC | High speed 12-bit monolithic D/A converter. High stability buried zener 10V reference. Error +-1/4LSB |
| MX7534TQ | MaximIC | Microprocessor-compatible, 14-bit DAC. INL +-1 LSB. |
| MAX6317HUK50BW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 5.000V, min reset timeout 20ms, typ watchdog timeout 6.3ms |
| MAX739CWE | MaximIC | -5V, inverting carrent-mode PWM regulator. |
| MAX6321HPUK50BZ-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 5.000V, reset timeout(min) 20ms, watchdog timeout(typ) 25.6sec |
| MAX6319LHUK35D-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-low,push/pull and active-high, push/pull).Factory-trimmed reset threshold(typ) 3.500V, reset timeout(min) 1120ms |
| MAX6319LHUK39B-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-low,push/pull and active-high, push/pull).Factory-trimmed reset threshold(typ) 3.900V, reset timeout(min) 20ms |
| MAX706SCSA | MaximIC | Low-cost, microprocessor supervisory circuit. Precison supply-voltage monitor 2.93V. Active-low reset output signal. |
| MAX199AMYI | MaximIC | Multi-range (+-4V, +-2V, +4V, +2V), +5V supply, 12-bit DAS with 8+4 bus interface |
| MAX6321HPUK28BX-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 2.800V, reset timeout(min) 20ms, watchdog timeout(typ) 102ms |
| MAX369EJN | MaximIC | Fault-protected analog multiplexer with latch. 4 channel differential (2 of 8). |
| MAX6350MJA | MaximIC | Low-noise, +5V voltage reference. Max tempco 2.5ppm/C |
| MAX6322HPUK26A-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 2.630V, reset timeout(min) 1ms |
| MAX4552ESE | MaximIC | +-15kV ESD-protected, quad, low-voltage, SPST analog switches (four NO switches). |
| MAX7415EPA | MaximIC | 5th-order, lowpass, elliptic, switched-capacitor filter. Transition ratio r = 1.25, operating voltage +3V |
| MAX507BCNG | MaximIC | Voltage-output, 12-bit DAC with internal reference. 12 data-bus widths. Error +-3/4. |
| MAX4315ESE | MaximIC | High-speed, low-power, single-supply, multichannel, video multiplexer-amplifier. No. Of input channel 8. Amplifier gain +2V/V |
